Yamaha Tio1608-D Stagebox

Yamaha Tio1608-D Stagebox

รหัสสินค้า: 31BY01018 Brand: Yamaha

I/O Interfaces  YAMAHA Tio1608-D ดิจิตอล สเตจบ๊อกซ์ 16 Input 8 Output 16 Mic

  • Stage Box I/O 16 in, 8 out, (XLR) สำหรับ TF Series
  • รองรับการใช้งานพร้อมกันได้สูงสุด 3 เครื่อง
  • Sampling Rate 44.1kHz หรือ 48 kHz
  • DANTE network ใช้งานร่วมกับ NY64-D
  • 3U size

76,000.00฿

สอบถาม / สั่งซื้อสินค้า / ขอใบเสนอราคา กรุณาติดต่อที่
More information / Order / Quotation please contact.

Email : [email protected]
Tel : 089-786-6306
Line ID : @ctmusicshop Add Friend

รายละเอียดเพิ่มเติม...

Plug In & Play Dante Stagebox Solution

The Tio1608-D is a Dante-equipped I/O rack with 16 microphone/ line inputs and 8 line outputs. Tio racks feature the same recallable D-PRE™ microphone preamplifiers as the TF series delivering extraordinarily natural and musical sound. In combination with TF series consoles, Tio racks can be connected using up to three units with a fast and easy setup. * Optional NY64-D Card is required.

Flexible system expansion via Dante

Dante Network Audio Protocol has been adopted, not only in TF, but also in other Yamaha digital mixing consoles such as CL/QL. Combining these I/O racks and the various consoles can significantly increase the flexibility of system designs. Patching can be enabled via “Dante Controller” while Remote HA can be controlled by “R Remote” software. Audio patching and Remote HA can be controlled not only from TF but also from CL/QL.
* Please note that Remote HA of the Tio1608-D can be implemented only via the Primary port. Remote HA control of Tio1608D is not available on the secondary network, even when you are using with TF or CL/QL.

Digital Stagebox System with a Maximum of 3 units

Users wishing to expand on the TF’s already extensive input/output capability can easily add up to 3 units with the optional NY64-D expansion card and Tio1608-D I/O racks. Daisy-chaining the main console offstage and Tio1608-D I/O racks on stage using lightweight CAT5e Ethernet cables allows low-latency, high-quality sound transmission without the time-consuming transport and setup of bulky analog snakes.

Dante High Reliability Network Audio Protocol

Dante has been adopted by the leading manufacturers and professionals in the sound reinforcement industry for its low jitter, low latency, and high sampling accuracy. Using the Tio1608-D you can easily configure a high-performance Dante stagebox system with little or no IT networking knowledge. Thanks to the flexibility of the Dante network protocol, TF Series consoles can be connected to an extensive range of Dante-enabled equipment such as R Series I/O racks.

Fast and Easy QUICK CONFIG Mode

By enabling the QUICK CONFIG mode on the Tio1608-D, all the connection settings such as network settings and audio patching are set automatically making system configuration easy.

After confirming QUICK CONFIG mode is activated on the TF console and Tio racks, simply set a UNIT ID for each Tio1608-D, then daisy chain the TF console and the Tio racks. Turn on the power and you’re ready to go!

Simple and Flexible Input Selection

Once the basic configuration is completed you can easily assign inputs to best suit your system setup.

By using the ALL INPUT function, users can assign all inputs to the Tio racks, the TF console or a PC/Mac device instantly.

Users can also change each input to receive signal from multiple locations so that users can effectively use all inputs.

Recallable D-PRE preamplifiers

The Tio1608-D inherits the natural, musical sensibility that we pursued in the development of the TF Series.

Mechanical construction, circuit board layout, power supply, grounding, and parts selection have all been executed with meticulous attention to detail and quality, combined with exhaustive performance and listening tests at each stage of development.

The Tio1608-D features the same recallable D-PRE microphone preamplifiers as the TF Series to provide a consistent, natural, musical sound throughout the entire system.

สเปค

Tio1608-D

Rio3224-D

Rio1608-D

Ri8-D

Ro8-D

Sound Philosophy

Natural Sound Concept

Grade

D-PRE

Inherit the sublime sound of PM series

Sampling Rate

44.1/48kHz

44.1/48/88.2/96kHz

Indicators

+48V

Sig, Peak, +48V

Sig

Gain Compensation

N/A

Supported

HA Control Redundancy from CL/QL consoles

N/A

(Primary only)

Supported

Controllability from R Remote software

Supported

Maximum number of units using HA remotes per system

Up to 3

Up to 8

AD8HR mode (HA control from M7CL and LS9)

N/A

Supported

Analog Inputs

16

32

16

8

0

Analog Input Connector

Combo Jack

XLR-3-31 Type

Analog Outputs

8

16

8

0

8

AES/EBU Outputs

0

8 (4ST)

0

0

0

AC Inlet

Normal

V-Lock Type

Heights

2U

5U

3U

1U

1U

General Specifications

General specifications

Tio1608-D

Sampling frequency rate

External

44.1kHz or 48kHz

Total harmonic distortion

Less than 0.1% +4dBu@20Hz-20kHz into 600Ω, Gain=+66dB / Less than 0.05% +4dBU@20Hz-20kHz into 600Ω, Gain=-6dB, INPUT to OUTPUT, Fs=44.1kHz, 48kHz *Measured with a -18dB/octave filter @80kHz

Frequency response

+0.5, -1.5dB 20Hz-20kHz, refer to the nominal output level @1kHz, INPUT to OUTPUT, Fs=44.1kHz or 48kHz

Dynamic range

108 dB, INPUT to OUTPUT, Gain=-6dB / 112 dB, DA Converter

Hum & noise level

Equivalent input noise

-128dBu, Gain=+66dB *Measured with A-weighting filter

Residual output noise

-88dBu, ST master off *Measured with A-weighting filter

Crosstalk

-100dB, adjacent INPUT/OUTPUT channels, Input Gain = -6dB *Measured with a -30dB/octave filter @22kHz

Heat dissipation

100-240V, 50/60Hz, 43.5kcal/h

Power requirements

100-240V, 50/60Hz

Power consumption

50W

Dimensions

W

480mm (18-7/8″)

H

88mm (3-4/8″)

D

364mm (14-3/8″)

Net weight

5.7kg (12.6lbs)

Accessories

Owner’s Manual, Power Cord(2.5m), Rubber stoppers(4)

Others

Temperature Range: Operating temperature range: 0 – 40℃, Storage temperature range: -20 – 60℃

Analog Input Characteristics

Input Terminals

GAIN

Actual Load
Impedance

For Use With
Nominal

Input Level

Connector

Balanced /
Unbalanced

Sensitivity*1

Nominal

Max. before clip

INPUT1-16

+66dB

7.5kΩ

50-600Ω Mics &

600Ω Lines

-82dBu (61.6μV)

-62dBu (0.616mV)

-42dBu (6.16mV)

Combo Jack (XLR-3-31 type *2

or TRS phone *3)

Balanced

-6dB -10dBu (245mV) +10dBu (2.45V) +30dBu (24.5V)

In these specifications, 0dBu = 0.775Vrms.
+48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.
*1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain.
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND

Analog Output Characteristics

Output Terminals

Actual Source
Impedance

For Use With
Nominal

Output Level

Connector

Balanced /
Unbalanced

Nominal

Max. before clip

OUTPUT 1-8

75Ω

600Ω Lines

+4dBu (1.23 V)

+24dBu (12.3V)

XLR-3-32 type*1

Balanced

In these specifications, 0dBu = 0.775Vrms.
*1.1: GND,2: HOT, 3: COLD

Digital Input & Output Characteristics

Terminal

Format

Data length

Level

Audio

Connector

Primary/Secondary

Dante

24bit or 32bit

1000Base-T

16ch ( Tio1608-D to other devises)

8ch (Other devises to Tio1608-D)

etherCON Cat5e

JISOO CHU

สอบถาม / สั่งซื้อสินค้า / ขอใบเสนอราคา กรุณาติดต่อที่
More information / Order / Quotation please contact.

Email : [email protected]
Tel : 089-786-6306
Line ID : @ctmusicshop Add Friend

รีวิวจากลูกค้าตัวจริง

บิ๊ก Paradox


ที่ CT Music มีอุปกรณ์เครื่องดนตรี และอุปกรณ์อัดเสียงหลายอย่างที่ต้องการ ขอบคุณการบริการที่ยอดเยี่ยมสะดวกและรวดเร็วนะครับ ขอบคุณ ct music ครับ

webmaster

บูม The Yers


สวัสดีปีใหม่ ถ้าอยากได้กีตาร์ใหม่ สวัสดี CT

webmaster

ต่อ The Yers


สำหรับผม CT ไม่ใช่แค่ร้านขายเครื่องดนตรี แต่เป็นมิตรภาพที่ให้กันมาตลอดชีวิตที่อยู่ในวงการดนตรี

CT Admin

คำถามที่พบบ่อย

  • ร้านเปิดเวลาไหนบ้าง?
  • ร้านเปิดทุกวัน เวลาทำการ 10.00 – 18.30 น.
  • ร้าน CT Music Shop ตั้งอยู่ที่ไหน?
  • ตั้งอยู่ในซอยเชื่อมระหว่างซอยสุขุมวิท 38 และ 40 สำหรับท่านที่มาเป็นครั้งแรกแนะนำให้มาจากทางซอยสุขุมวิท 38 เนื่องจากเดินทางได้สะดวกกว่า (ซอยสุขุมวิท 40 เป็นซอย one way ถ้าเลยอาจจะกลับรถลำบาก) โดยซอยสุขุมวิท 38 ตั้งอยู่ใต้สถานีรถไฟฟ้าทองหล่อพอดี สามารถลงจากรถไฟฟ้าทองหล่อ ออกทางออกที่ 4 ลงมาก็จะเจอกับซอยสุขุมวิท 38 ทันที ร้านตั้งอยู่ในซอยเข้ามาประมาณ 600 เมตร ก็จะเจอซอยเลี้ยวซ้ายซึ่งเป็นซอยเชื่อมกับซอยสุขุมวิท 40 (เป็นเลี้ยวซ้ายเดียวที่มีในซอย 38) เมื่อเลี้ยวซ้ายมาแล้วร้านจะอยู่ซ้ายมือทันทีเป็นตึกอาคารชุดสีน้ำตาลสองแถวหันหน้าเข้าหากัน (ร้านอยู่ฝั่งขวาครับ)